Analytes Certified for in 2025 |
|
|---|---|
| Certifications Menu | |
Acid-extractable Phosphorus (9G2)
This test is often referred to as BSES-P. Soil extracts are obtained by shaking milled air-dry soil at a ratio of 1:200 (w/v) with 0.005M sulfuric acid for 16 h. Method 9G1 codes the manual analytical finish of Truog and Meyer, with absorbance at 660 nm. Method 9G2 codes automated analytical finishes (continuous segmented flow and flow injection analysis) based on molybdenum-blue and a preferred absorbance of 882 nm. The methods specify reporting results as mg P/kg on an air-dry basis.Bicarbonate Extractable Phosphorus - Colwell (9B2)
This popular Australian P test on milled air-dry sample is suitable for acidic, neutral and alkaline soils. The extractant is freshly prepared 0.5M sodium bicarbonate @ pH 8.5. The wide soil/extractant ratio of 1:100 and an extended shaking time of 16 h favours readily available and more slowly available forms of soil P, while suppressing the solubility of basic calcium phosphates often found in neutral and alkaline soils.
Method 9B1 describes a manual, molybdenum-blue colorimetric procedure with a preferred absorbance at 882 nm, whereas Method 9B2 refers to the same initial soil extraction, followed by an equivalent automated molybdenum-blue colorimetric finish (continuous segmented flow or flow injection analysis). The methods specify reporting results as mg P/kg on an air-dry basis.
Electrical conductivity (EC) of 1:5 soil/water extract (3A1)
This test on milled air-dry sample at a soil/water ratio of 1:5 for 1 h is suitable for use on all soils, irrespective of whether acidic or alkaline. It usually underestimates the soluble salt status of soils containing natural or added gypsum, particularly if ³ 1% of gypsum is present. Such soils would have an EC of about 2 dS/m. Soil EC x 0.336 (Method 3B1) approximates percent total soluble salts, while approximate soil ionic strength (Method 3C1) at 0.1 bar (I0.1) can be calculated as follows: I0.1 = [0.0446*EC1:5 – 0.000173], where I0.1 has units of mM, and EC1:5 has units of dS/m @ 25oC.
4B2+4B4 (4B4)
This pH test on milled air-dry sample is suitable for use on all soils, irrespective of whether acidic or alkaline. Values are usually unaffected by fertilisation prior to sampling, as changes to the soil’s ionic strength is masked by the calcium chloride. Code 4B4 indicates addition of 0.21M CaCl2 to a 1:5 soil/water suspension to achieve 0.01M CaCl2 prior to measurement of pH, with stirring. This test is usually conmbined with 4B2, where a water based pH is determined immediately prior to this CaCl2 pH.